Appendix
9836 3521 01 639
EPH: No TMU received, no connection to PLUS
EPH: Request of TMU failed, barcode has bad length (actual =
%d, expected = %d)
EPH: Data could not be sent, NACK received from I-P.M.
EPH: Data could not be sent, no answer from I-P.M.
EPH: Received TMU from PLUS not accepted, device already
busy
EPH: Received TMU from PLUS not accepted, device busy
sending cycledata
EPH: A non VBA station received a TMU without a request from
the TC
EPH: No program number defined, used PgmNo = 0 when
sending data to I-P.M.
EPH: The AFO no was too long, %d chars, only %d sent to I-
P.M.
EPH: No TMU received from PLUS, wrong IT type in received
telegram
EPH: Total length of IT and IW is %d chars. Truncated after %d
chars
EPH: Send data failed, Wp ID must start with specified VIN
number type
EPH: Send data failed, not possible to store data in PLUS (TC
received I*NQ)
EPH: Unknown or corrupt tgm received from PLUS (Error=%d,
tgm id=%d, state=%d)
EPH: Error when sending telegram to PLUS (Error=%d, tgm
id=%d, state=%d)
EPH: Device %d. No ACK (MID %d) received from Integrator,
closing connection
EPH: No connection to station %d
EPH: Group %d cannot be selected/deselected since it does not
exist
EPH: Chan. %d cannot be selected since it does not exist
EPH: Group %d cannot be deselected since it is not selected
EPH: Group %d is not valid for the operation
EPH: TAP/TNR cannot be added to chan. %d since it is not part
of group %d
EPH: Cannot enable group %d since it is not selected (no
GRS.GRP received)
To Next Page
Loading...
