Appendix
9836 3521 01 649
Step %d, Channel Angle%d for restriction (%d) does not exists
in spindle
Step %d, Torque channel for restriction (%d) has bad
configuration (%d)
Step %d, Channel Torque%d for restriction (%d) does not exists
in spindle
Step %d, Angle channel for steptype (%d) has bad configuration
(%d)
Step %d, Channel Angle%d for steptype (%d) does not exists in
spindle
Step %d, Torque channel for steptype (%d) has bad
configuration (%d)
Step %d, Channel Torque%d for steptype (%d) does not exists
in spindle
Cust. error series bad config. Step %d, Series %d, BoltStatus
%d. Series 1 used
Cust. error series bad config. Step %d, Series %d, BoltStatus
%d. Series 1 used
No step failed, used customer step name in first CE step (step
%d) instead
Step %d, Control: Local DI %d cannot be used since TC type is
not 'PTC'
Step %d, BCT measutement failed, old values are cleared
Backlash Angle Chan %d differ from stored chan %d, backlash
values are cleared
Step %d, Control: Speed or speed ramp has bad configuration
Step %d, Control: The selected position target has no stored
value
Step %d, Control: No prev. step direction stored, not possibel to
run POS step
Step %d, Zone has bad configuration
Step %d, Check: Peak torque failed, Zone %d was never started
Step %d, Check: Torque in angle window failed, Zone %d was
never started
Step %d, Check: Torque in time window failed, Zone %d was
never started
Step %d, Check: Mean torque failed, Zone %d was was not
finished
Step %d, Check: Angle failed, Zone %d was was not finished
To Next Page
Loading...
