Appendix
650 9836 3521 01
Step %d, Check: Time failed, Zone %d was never started
Step %d, Check: T/T3 failed, Zone %d was was not finished
Step %d, Check: Torque Rate calculation failed, Zone %d was
never started
Step %d, Res var have bad configuration. %d is not a valid cycle
data variable
Step %d, Check with identity %d has bad configuration
Step %d, Check: Delta torque failed, Zone %d was never started
Step %d, Check: Delta torque failed
Step %d, Check: Delta torque. %f > %f
Step %d, Check: Delta torque. %f < %f
Step %d has bad configuration, one or more paramters are
faulty, Step Type = %d
Step %d, The step is syncronized since Wait for PLC to continue
is checked.
Step %d, PosValid %d, Stored External Postion = %f
Acctual Internal position = %d, Acctual External position = %f
Step %d, Store of position register not possible, Angle channel
does not exist
The e-stop chain is broken somewhere between TC %d and the
primary TC (TC %d)
E-stop is faulty. TC %d (station TC) is e-stopped, some other
TCs isn't
Step %d, Check: Shut Off Torque failed, Zone %d was was not
finished
Step %d, T1 Shunt Cal NOK. Shunt drift from last cal too high,
%f > %f
Step %d, T2 Shunt Cal NOK. Shunt drift from last cal too high,
%f > %f
Step %d, T1 Zero Offset comp NOK. Drift from last cal too high
%f > %f
Step %d, T2 Zero Offset comp NOK. Drift from last cal too high
%f > %f
Step %d, T1 Shunt Calibration NOK. Measured Shunt too low
%f < %f
Step %d, T2 Shunt Calibration NOK. Measured Shunt too low
%f < %f
Step %d, T1 Shunt Calibration NOK. Measured Shunt too high
%f > %f
To Next Page
Loading...
Need help?
General
