Atlas Copco PowerMACS 4000

Contents
8 9836 3521 01
6.5.2.28 POS - Run to Position (only available for Gauging) .............................................. 305
6.5.3 Step – Restriction .................................................................................................................... 307
6.5.3.1 Fail Safe Torque ....................................................................................................... 308
6.5.3.2 Fail Safe Time .......................................................................................................... 309
6.5.3.3 Fail Safe Angle ........................................................................................................ 310
6.5.3.4 Min Torque Restriction ............................................................................................ 311
6.5.3.5 Gradient ................................................................................................................... 313
6.5.3.6 Cross Thread and Gradient ...................................................................................... 315
6.5.3.7 Torque Profile .......................................................................................................... 316
6.5.3.8 Angle Difference ...................................................................................................... 318
6.5.3.9 Torque Difference .................................................................................................... 319
6.5.4 Step – Check ........................................................................................................................... 320
6.5.4.1 Result values from checks ........................................................................................ 321
6.5.4.2 Check peak torque .................................................................................................... 322
6.5.4.3 Check torque in angle window ................................................................................. 324
6.5.4.4 Check torque in time window .................................................................................. 325
6.5.4.5 Check mean torque .................................................................................................. 326
6.5.4.6 Check angle .............................................................................................................. 327
6.5.4.7 Check Post view Torque .......................................................................................... 329
6.5.4.8 Check T/T3 (Current as Torque) .............................................................................. 331
6.5.4.9 Check shut off torque ............................................................................................... 332
6.5.4.10 Check torque rate ................................................................................................... 333
6.5.4.11 Check Zero Crossing (only available for Gauging) .............................................. 336
6.5.4.12 Check time ............................................................................................................. 338
6.5.4.13 Check Yield Point Angle ....................................................................................... 338
6.5.4.14 Check Stick Slip ..................................................................................................... 340
6.5.4.15 Delta T (only available for Gauging) ..................................................................... 342
6.5.4.16 Low Spot Torque (only available for Gauging) ..................................................... 343
6.5.4.17 Check Position (only available for Gauging) ......................................................... 343
6.5.4.18 Check Backlash angle (only available for Gauging) .............................................. 344
6.5.4.19 Check external input (only available for Gauging) ................................................ 344
6.5.5 Step – Rejects .......................................................................................................................... 345
6.5.5.1 Checking the bolt status ........................................................................................... 346
6.5.5.2 Deciding what to do ................................................................................................. 347
6.5.5.3 Configuring Reject Management ............................................................................. 350
6.5.5.4 Advanced RM Actions ............................................................................................. 352
6.5.5.5 Cycle RM ................................................................................................................. 353
6.5.5.6 Reject management states ........................................................................................ 355
6.5.5.7 Reject management examples .................................................................................. 361
6.5.6 Step – Ramps & Other ............................................................................................................ 363
6.5.6.1 Ramps & Other – Ramps ......................................................................................... 364