Contents
9836 3521 01 7
5.6 PLC Parameters .................................................................................................................................. 256
5.7 Display PLC Status ............................................................................................................................. 257
6 Tightening......................................................................................................................................... 258
6.1 Tightening - Overview........................................................................................................................ 258
6.2 Create a new Tightening Program ...................................................................................................... 259
6.3 The Tightening Program form ............................................................................................................ 260
6.3.1 Tightening Program step operations ........................................................................................ 262
6.4 The Mode Table form ......................................................................................................................... 264
6.5 Tightening Program ............................................................................................................................ 266
6.5.1 Program Properties .................................................................................................................. 268
6.5.1.1 Program Common properties ................................................................................... 268
6.5.1.2 Program User variables ............................................................................................ 268
6.5.1.3 Program Settings ...................................................................................................... 270
6.5.2 Step – Control ......................................................................................................................... 273
6.5.2.1 DT - Run until Dyna-Tork
TM
................................................................................... 274
6.5.2.2 DT2 - Run until Dyna-Tork
TM
, method 2................................................................. 276
6.5.2.3 DT3 - Run until Dyna-Tork
TM
, method 3................................................................. 277
6.5.2.4 T - Run until Torque ................................................................................................ 278
6.5.2.5 TC - Run until Torque with Current Control ........................................................... 279
6.5.2.6 AO - Run until Angle with overshoot compensation ............................................... 280
6.5.2.7 A - Run until Angle .................................................................................................. 282
6.5.2.8 Y1 - Run until Yield point, method 1 ...................................................................... 283
6.5.2.9 Y2 - Run until Yield point, method 2 ...................................................................... 284
6.5.2.10 LT - Loosen until torque ........................................................................................ 285
6.5.2.11 RA - Release angle ................................................................................................. 287
6.5.2.12 PA - Run until Projected angle ............................................................................... 289
6.5.2.13 TD - Run until Torque has decreased..................................................................... 290
6.5.2.14 TI - Run until Time ................................................................................................ 291
6.5.2.15 E1 - Run Engage method 1 .................................................................................... 291
6.5.2.16 E2 - Run Engage method 2 .................................................................................... 291
6.5.2.17 NS - Run until next step ......................................................................................... 291
6.5.2.18 GS - Run Gear Shift ............................................................................................... 292
6.5.2.19 PLC - Run PLC step............................................................................................... 292
6.5.2.20 JOG - Run until digital input goes high / low ........................................................ 293
6.5.2.21 W - Wait ................................................................................................................. 293
6.5.2.22 TA – Run Torque-Angle with no stop ................................................................... 294
6.5.2.23 SR – Socket Release .............................................................................................. 300
6.5.2.24 ADT-Angle Delta Torque ...................................................................................... 301
6.5.2.25 SG - Snug Gradient ................................................................................................ 303
6.5.2.26 D - Diagnostic Step ................................................................................................ 304
6.5.2.27 BCT – Backlash correction (only available for Gauging) ...................................... 305
To Next Page
Loading...
Need help?
General
