SmartROC D65 Tier 4 Final 5 RCS drilling system
60
n Ignore chair switch: Normally you have to sit in the seat to operate the positioning
levers. If the box is checked, you can leave the seat for 10 seconds and still carry out
positioning.
n Emergency mode, Length Sensor: Used if the length sensor has stopped working.
None of the pre-programmed stops will work but the rig can be used until the length
sensor has been rectified. Use rapid feed with great care as none of the stops are
working.
n Emergency mode RHS: Used if an RHS sensor has stopped working. No stops are
working but the rig can still be used with great care.
n Emergency mode, Break Table: Normally, the breaking is semi-automatic. Activa-
tion allows full manual breaking.
n Emergency mode, Water Mist: Normally the watermist system is switched off when
the water level in the tank is low (warning in the status bar). If, for example, the level
sensor is inoperative then the watermist system can still be used.
n Beacon on: Indicates when the warning beacon should be switched on.
n Units of Measurement: Select Metric/Imperial units.
n Increase (+) or decrease (-) the brightness of the display.
n Activate HECL-Pump manually: Pump up oil to the rotation unit for a certain time
without flushing air being on. Used for example when you have a new down-the-hole
drill.
n Ignore chair switch: Normally you have to sit in the seat to operate the positioning
levers. If the box is checked, you can leave the seat for 10 seconds and still carry out
positioning.
n Emergency mode, Length Sensor: Used if the length sensor has stopped working.
None of the pre-programmed stops will work but the rig can be used until the length
sensor has been rectified. Use rapid feed with great care as none of the stops are
working.
n Emergency mode RHS: Used if an RHS sensor has stopped working. No stops are
working but the rig can still be used with great care.
n Emergency mode, Break Table: Normally, the breaking is semi-automatic. Activa-
tion allows full manual breaking.
n Emergency mode, Water Mist: Normally the watermist system is switched off when
the water level in the tank is low (warning in the status bar). If, for example, the level
sensor is inoperative then the watermist system can still be used.
n Beacon on: Indicates when the warning beacon should be switched on.
n Units of Measurement: Select Metric/Imperial units.
n Water Mist Draining: When Enter is pressed the watermist system is blown clean for
20 seconds. The compressor must be switched on and flushing air must be switched
off. After blow-cleaning the watermist system must be switched off and flushing air
must be switched on in order to blow away the water from the flushing air hose.
To Next Page
Loading...
Need help?
General
