User's Manual 100 Document #: LTRT-89730
Mediant 3000
If you know the full path to a command inside one of the subdirectories, the short format
can be used to run it directly. For example, to run the PERFormance command in the
MGmt subdirectory, type the following:
/>MG/PERF
Note: The subdirectory names and commands are case-insensitive. For example, it
does not matter whether you type "MGmt" or "mgmt".
8.4.2 Status Commands
The following table summarizes the Show commands and their corresponding options.
Table 8-2: Show CLI Commands
Command Short Format Arguments Description
SHow
sh info | hw | tdm |
dsp | ip | log
Displays operational data.
 info: Displays general device information
 tdm: Displays PSTN-related information
 dsp: Displays DSP resource information
 ip: Displays information about IP interfaces
SHow INFO
sh info - Displays device hardware information,
versions, uptime, temperature reading, and the
last reset reason.
SHow HW sh hw -- Displays system information: power status,
High-Availability status, and fan information.
SHow TDM sh tdm status | perf |
summary
Displays the alarm status and performance
statistics for E1/T1 trunks.
SHow DSP
sh dsp status | perf Displays status and version for each DSP
device, along with overall performance
statistics.
SHow IP
sh ip conf | perf |
route
Displays IP interface status and configuration,
along with performance statistics.
Note: The display format may change
according to the configuration.
SHow LOG
sh log [stop] Displays (or stops displaying) Syslog
messages in the CLI session.
Example:
/>sh info
Board type: gateway SDH, firmware version 6.60.000.020
Uptime: 0 days, 0 hours, 3 minutes, 54 seconds
Memory usage: 63%
Temperature reading: 39 C
Last reset reason:
Board was restarted due to issuing of a reset from Web interface
Reset Time : 7.1.2012 21.51.13
/>sh tdm status
Trunk 00: Active
Trunk 01: Active
To Next Page
Loading...
Need help?
General
