Version 7.0 831 Mediant 3000
User's Manual 58. Configuration Parameters Reference
58 Configuration Parameters Reference
The device's configuration parameters, default values, and their descriptions are
documented in this section.
Note: Parameters and values enclosed in square brackets [...] represent the ini file
parameters and their enumeration values.
58.1 Management Parameters
This section describes the device's management-related parameters.
58.1.1 General Parameters
The general management parameters are described in the table below.
Table 58-1: General Management Parameters
Parameter Description
Web and Telnet Access
List Table
[WebAccessList_x]
This table configures up to ten IP addresses that are permitted to access
the device's Web interface and Telnet interfaces. Access from an
undefined IP address is denied. When no IP addresses are defined in
this table, this security feature is inactive (i.e., the device can be
accessed from any IP address).
The default is 0.0.0.0 (i.e., the device can be accessed from any IP
address).
For example:
WebAccessList_0 = 10.13.2.66
WebAccessList_1 = 10.13.77.7
For a description of the parameter, see ''Configuring Web and Telnet
Access List'' on page 93.
58.1.2 Web Parameters
The Web parameters are described in the table below.
Table 58-2: Web Parameters
Parameter Description
Password Change Interval
[WebUserPassChangeInte
rval]
Defines the duration (in minutes) of the validity of Web login passwords.
When this duration expires, the password of the Web user must be
changed.
The valid value is 0 to 100000, where 0 means that the password is
always valid. The default is 1140.
Note: The parameter is applicable only when using the Web Users
table, where the default value of the 'Password Age' parameter in the
Web Users table inherits the parameter's value.
User Inactivity Timer Defines the duration (in days) for which a user has not logged in to the
Web interface, after which the status of the user becomes inactive and
To Next Page
Loading...
Need help?
General
