AudioCodes Mediant 3000 User Manual

User's Manual 856 Document #: LTRT-89730
Mediant 3000
Parameter Description
April, at 11 P.M. The week field can be 1-5, where 5 denotes the last
occurrence of the specified day in the specified month. For example,
"04:FRI/05:23:00" denotes the last Friday of April, at 11 P.M.
End Time / Day of Month
End
[DayLightSavingTimeEnd]
Defines the date and time when DST ends. For a description of the
format of this value, see the DayLightSavingTimeStart parameter.
Offset
[DayLightSavingTimeOffs
et]
Defines the DST offset (in minutes).
The valid range is 0 to 120. The default is 60.
Note: The offset setting is applied only on the hour. For example, if you
configure the parameter at 15:42, the device applies the setting only at
16:00.
58.3 Debugging and Diagnostics Parameters
This subsection describes the device's debugging and diagnostic parameters.
58.3.1 General Parameters
The general debugging and diagnostic parameters are described in the table below.
Table 58-18: General Debugging and Diagnostic Parameters
Parameter Description
[EnableDiagnostics] Determines the method for verifying correct functioning of the different
hardware components on the device. On completion of the check and if
the test fails, the device sends information on the test results of each
hardware component to the Syslog server.
 [0] = (Default) Rapid and Enhanced self-test mode.
 [1] = Detailed self-test mode (full test of DSPs, PCM, Switch, LAN,
PHY and Flash).
 [2] = A quicker version of the Detailed self-test mode (full test of
DSPs, PCM, Switch, LAN, PHY, but partial test of Flash).
Note: For the parameter to take effect, a device reset is required.
LAN Watchdog
[EnableLanWatchDog]
Enables the LAN watchdog feature. The LAN watchdog detects any
logical network failure.
 [0] Disable (default)
 [1] Enable & Reset = Enables LAN watchdog. If the device detects a
network failure, the device resets.
 [2] Enable & No Reset = Enables LAN watchdog. If the device
detects a network failure, it does not undergo a reset.
The LAN watchdog periodically checks the device's overall
communication integrity by pinging the network. If the device detects a
communication failure lasting longer than three minutes, it performs a
self-test:
 Test succeeds: The problem is due to a logical link failure (i.e., the
Ethernet cable has been disconnected on the remote switch) and the
following mechanisms are activated if enabled:

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English