AudioCodes Mediant 3000 User Manual

Version 7.0 1053 Mediant 3000
User's Manual 58. Configuration Parameters Reference
Table 58-73: SIP-based Media Recording Parameters
Parameter Description
SIP Recording Application
[EnableSIPRec]
Enables the SIP-based Media Recording feature:
 [0] Disable (default)
 [1] Enable
Note: For the parameter to take effect, a device reset is required.
Recording Server (SRS)
Destination Username
[SIPRecServerDestUserna
me]
Defines the SIP user part for the recording server. This user part is
added in the SIP To header of the INVITE message that the device
sends to the recording server.
The valid value is a string of up to 50 characters. By default, no user
part is defined.
SIP Recording Table
SIP Recording table
[SIPRecRouting]
Defines SIP Recording Routing rules (for siprec).
The format of the ini file table parameter is as follows:
[ SIPRecRouting ]
FORMAT SIPRecRouting_Index =
SIPRecRouting_RecordedIPGroupName,
SIPRecRouting_RecordedSourcePrefix,
SIPRecRouting_RecordedDestinationPrefix,
SIPRecRouting_PeerIPGroupName,
SIPRecRouting_PeerTrunkGroupID, SIPRecRouting_Caller,
SIPRecRouting_SRSIPGroupName;
[ \SIPRecRouting ]
For a description of the table, see ''Configuring SIP Recording Rules''
on page 234.
58.14.2 RADIUS and LDAP Parameters
58.14.2.1 General Parameters
The general RADIUS and LDAP parameters are described in the table below.
Table 58-74: General RADIUS and LDAP Parameters
Parameter Description
Use Local Users Database
[MgmtUseLocalUsersData
base]
Defines when the device uses its local management-users database
(Web Users table) or an LDAP/RADIUS server for authenticating the
login credentials (username-password) of users when logging into the
device's management interface (e.g., Web or CLI).
 [0] When No Auth Server Defined = (Default) The device
authenticates the users usng the Web Users table in the following
scenarios:

If no LDAP/RADIUS server is configured.

If an LDAP/RADIUS server is configured, but connectivity with
the server is down. If there is connectivity with the server, the
device uses the server to authenticate the user.
 [1] Always = The device first attempts to authenticate the user using
the Web Users table. If no user is found (based on the username-
password combination), it attempts to authenticate the user using the

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English