AudioCodes Mediant 3000

User's Manual 846 Document #: LTRT-89730
Mediant 3000
58.2 Networking Parameters
This subsection describes the device's networking parameters.
58.2.1 Ethernet Parameters
The Ethernet parameters are described in the table below.
Table 58-9: Ethernet Parameters
Parameter Description
[EthernetPhyConfiguration
]
Defines the Ethernet connection mode type.
 [0] = 10Base-T half-duplex (Not applicable)
 [1] = 10Base-T full-duplex
 [2] = 100Base-TX half-duplex (Not applicable)
 [3] = 100Base-TX full-duplex
 [4] = (Default) Auto-negotiate
 [6] = 1000Base-TX half-duplex (Not applicable)
 [7] = 1000Base-TX full-duplex
Note: For the parameter to take effect, a device reset is required.
58.2.2 Multiple VoIP Network Interfaces and VLAN Parameters
The IP network interfaces and VLAN parameters are described in the table below.
Table 58-10: IP Network Interfaces and VLAN Parameters
Parameter Description
Interface Table
Interface Table
[InterfaceTable]
The table configures the Interface table.
The format of the ini file table parameter is as follows:
[InterfaceTable]
FORMAT InterfaceTable_Index = InterfaceTable_ApplicationTypes,
InterfaceTable_InterfaceMode, InterfaceTable_IPAddress,
InterfaceTable_PrefixLength, InterfaceTable_Gateway,
InterfaceTable_VlanID, InterfaceTable_InterfaceName,
InterfaceTable_PrimaryDNSServerIPAddress,
InterfaceTable_SecondaryDNSServerIPAddress,
InterfaceTable_UnderlyingDevice;
[\InterfaceTable]
For a detailed description of the table, see ''Configuring IP Network
Interfaces'' on page 145.
Physical Network Separation Feature Parameters
Network Physical
Separation
[EnableNetworkPhysicalS
eparation]
Enables the Physical Network Separation feature where network
interface types (Media, Control, and OAMP) are allocated to dedicated
ports. To define the port allocation, see the
PhysicalSeparationConfiguration parameter.
 [0] Disable (default)
 [1] Enable