User's Manual 104 Document #: LTRT-89730
Mediant 3000
Src number: 700
Cid display: TESTING
DTMFs String 112233
Time After DTMF are sent: 20 sec
/SIP>tc connect
Start Test call.
Receive ALERT Event
Receive Connect
Wait more 20 seconds before disconnecting
Receive SS_TIMER_EV Event
Send Release To Call
Receive RELEASE_ACK Event
Receive SS_TIMER_EV Event
8.4.5 Management Commands
The commands under the MGmt directory, described in the table below, display current
performance values.
Table 8-6: CLI Management Command
Command Short Format Arguments Description
/MGmt/PERFormance
/mg/perf basic | control | dsp |
net | ds1 | reset
Displays performance statistics.
The reset argument clears all
statistics to zero.
8.4.6 Configuration Commands
The commands under the CONFiguration directory query and modify the current device
configuration. The following commands are available:
Table 8-7: Configuration CLI Commands
Command Short
Format
Arguments Description
SetConfigParam IP
/conf/scp ip ip-addr subnet def-
gw
Sets the IP address, subnet mask,
and default gateway address of the
device (on-the-fly).
Note: This command may cause
disruption of service. The CLI session
may disconnect since the device
changes its IP address.
RestoreFactorySetting
s
/conf/rfs
Restores all parameters to factory
settings.
SaveAndRestart
/conf/sar
Saves all current configurations to the
non-volatile memory and resets the
device.
ConfigFile
/conf/cf view | get | set
Retrieves the full ini file from the
device and allows loading a new ini
file directly in the CLI session.
Note: The argument view displays
the file, page by page. The argument
get displays the file without breaks.
To Next Page
Loading...
Need help?
General
