AudioCodes Mediant 3000 User Manual

Version 7.0 1017 Mediant 3000
User's Manual 58. Configuration Parameters Reference
Parameter Description
Gateway Routing Policy
[GWRoutingPolicy]
Edits the Gateway Routing Policy.
The format of the ini file table parameter is as follows:
[ GwRoutingPolicy ]
FORMAT GwRoutingPolicy_Index = GwRoutingPolicy_Name,
GwRoutingPolicy_LCREnable,
GwRoutingPolicy_LCRAverageCallLength,
GwRoutingPolicy_LCRDefaultCost,
GwRoutingPolicy_LdapServersGroupName;
[ \GwRoutingPolicy ]
For a description of the table, see ''Configuring a Gateway Routing
Policy Rule'' on page 510.
58.10.11 IP Connectivity Parameters
The IP connectivity parameters are described in the table below.
Table 58-66: IP Connectivity Parameters
Parameter Description
Enable Alt Routing Tel to IP
[AltRoutingTel2IPEnable]
Enables the Alternative Routing feature for Tel-to-IP calls.
 [0] Disable = (Default) Disables the Alternative Routing feature.
 [1] Enable = Enables the Alternative Routing feature.
 [2] Status Only = The Alternative Routing feature is disabled, but
read-only information on the QoS of the destination IP addresses is
provided.
Alt Routing Tel to IP Mode
[AltRoutingTel2IPMode]
Determines the IP Connectivity event(s) reason for triggering Alternative
Routing.
 [0] None = Alternative routing is not used.
 [1] Connectivity = Alternative routing is performed if a ping or SIP
OPTIONS message to the initial destination fails (determined
according to the AltRoutingTel2IPConnMethod parameter).
 [2] QoS = Alternative routing is performed if poor QoS is detected.
 [3] Both = (Default) Alternative routing is performed if either ping or
SIP OPTIONS to initial destination fails, poor QoS is detected, or the
DNS host name is not resolved.
Notes:
 QoS is quantified according to delay and packet loss calculated
according to previous calls. QoS statistics are reset if no new data is
received within two minutes.
 To receive quality information (displayed in the 'Quality Status' and
'Quality Info.' fields in ''Viewing IP Connectivity'' on page 754) per
destination, the parameter must be set to 2 or 3.
Alt Routing Tel to IP
Connectivity Method
[AltRoutingTel2IPConnMet
hod]
Determines the method used by the device for periodically querying the
connectivity status of a destination IP address.
 [0] ICMP Ping = (Default) Internet Control Message Protocol (ICMP)
ping messages.
 [1] SIP OPTIONS = The remote destination is considered offline if
the latest OPTIONS transaction timed out. Any response to an
OPTIONS request, even if indicating an error, brings the connectivity

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English