Version 7.0 269 Mediant 3000
User's Manual 16. Services
The flowchart below summarizes the device's process for querying the AD and routing the
call based on the query results:
Figure 16-24: LDAP Query Flowchart
Note: If you are using the device's local LDAP cache, see ''Configuring the Device's
LDAP Cache'' on page 258 for the LDAP query process.
16.3.12.2 Configuring AD-Based Routing Rules
The following procedure describes how to configure outbound IP routing based on LDAP
queries.
To configure LDAP-based IP routing for Lync Server:
1. Configure the LDAP server parameters, as described in ''Configuring LDAP Servers''
on page 250.
2. Configure the AD attribute names used in the LDAP query:
To Next Page
Loading...
