AudioCodes Mediant 3000

Version 7.0 347 Mediant 3000
User's Manual 18. Control Network
Parameter Description
SIP Group Name
[IPGroup_SIPGroupName
]
Defines the SIP Request-URI host name in INVITE and REGISTER
messages sent to this IP Group, or the host name in the From header of
INVITE messages received from this IP Group. In other words, it
replaces the original host name.
The valid value is a string of up to 100 characters. By default, no value is
defined.
Notes:
 If the parameter is not configured, the value of the global parameter,
ProxyName is used instead (see ''Configuring Proxy and Registration
Parameters'' on page 368).
 The parameter overrides inbound message manipulation rules that
manipulate the host name in Request-URI, To, and/or From SIP
headers. If you configure the parameter and you want to manipulate
the host name in any of these SIP headers, you must apply your
manipulation rule (Manipulation Set ID) to the IP Group as an
Outbound Message Manipulation Set (see the
IPGroup_OutboundManSet parameter), when the IP Group is the
destination of the call. If you apply the Manipulation Set as an
Inbound Message Manipulation Set (see the
IPGroup_InboundManSet parameter), when the IP Group is the
source of the call, the manipulation rule is overridden by the SIP
Group Name parameter.
 If the IP Group is of User type, the parameter is used internally as a
host name in the Request-URI for Tel-to-IP initiated calls. For
example, if an incoming call from the device's T1 trunk is routed to a
User-type IP Group, the device first creates the Request-URI
(<destination_number>@<SIP Group Name>), and then it searches
the registration database for a match.
UUI Format
CLI: uui-format
[IPGroup_UUIFormat]
Enables the generation of the Avaya UCID value, adding it to the
outgoing INVITE sent to this IP Group.
 [0] Disabled (default)
 [1] Enabled
This provides support for interworking with Avaya equipment by
generating Avaya's UCID value in outgoing INVITE messages sent to
Avaya's network. The device adds the UCID in the User-to-User SIP
header.
Avaya's UCID value has the following format (in hexa
decimal): 00 + FA +
08 + node ID (2 bytes) + sequence number (2 bytes) + timestamp (4
bytes)
This is interworked in to the SIP header as follows:
User-to-User: 00FA080019001038F725B3;encoding=hex
Note: To define the Network Node Identifier of the device for Avaya
UCID, use the 'Network Node ID' (NetworkNodeId) parameter.
QoE Profile
[IPGroup_QOEProfile]
Assigns a Quality of Experience Profile rule.
By default, no value is defined (None).
For configuring Quality of Experience Profiles, see ''Configuring Quality
of Experience Profiles'' on page 309.
Media Enhancement Assigns a Media Enhancement Profile rule.