AudioCodes Mediant 3000

Version 7.0 353 Mediant 3000
User's Manual 18. Control Network
Parameter Description
Authentication Method List
[IPGroup_MethodList]
Defines SIP methods received from the IP Group that must be
challenged by the device when the device acts as an Authentication
server. If no methods are configured, the device doesn't challenge any
methods.
By default, no value is defined. To define multiple SIP methods, use the
backslash ( \ ) to separate each method (e.g., INVITE\REGISTER).
Note: The parameter is applicable only if the 'Authentication Mode'
parameter is set to SBC as Server [2].
Username
[IPGroup_Username]
Defines the shared username for authenticating the IP Group, when the
device acts as an Authentication server.
The valid value is a string of up to 51 characters. By default, no
username is defined.
Notes:
 The parameter is applicable only to Server-type IP Groups and when
the 'Authentication Mode' parameter is set to SBC as Server (i.e.,
authentication of servers).
 To specify the SIP request types (e.g., INVITE) that must be
challenged by the device, use the 'Authentication Method List'
parameter.
Password
IPGroup_Password]
Defines the shared password for authenticating the IP Group, when the
device acts as an Authentication server.
The valid value is a string of up to 51 characters. By default, no
password is defined.
Notes:
 The parameter is applicable only to Server-type IP Groups and when
the 'Authentication Mode' parameter is set to SBC as Server (i.e.,
authentication of servers).
 To specify the SIP request types (e.g., INVITE) that must be
challenged by the device, use the 'Authentication Method List'
parameter.
Source URI Input
[IPGroup_SourceUriInput]
Defines the SIP header in the incoming INVITE that is used for call
matching characteristics based on source URIs.
 [-1] Not Configured (default)
 [0] From
 [1] To
 [2] Request-URI
 [3] P-Asserted - First Header
 [4] P-Asserted - Second Header
 [5] P-Preferred
 [6] Route
 [7] Diversion
 [8] P-Associated-URI
 [9] P-Called-Party-ID
 [10] Contact
 [11] Referred-by
Notes:
 The parameter is applicable only when classification is done
according to the Classification table.