User's Manual 440 Document #: LTRT-89730
Mediant 3000
Table 22-1: CAS State Machine Parameters Description
Parameter Description
Generate Digit On Time
[CasStateMachineGenerate
DigitOnTime]
Generates digit on-time (in msec).
The value must be a positive value. The default is -1 (use value from
CAS state machine).
Generate Inter Digit Time
[CasStateMachineGenerateI
nterDigitTime]
Generates digit off-time (in msec).
The value must be a positive value. The default is -1 (use value from
CAS state machine).
DTMF Max Detection Time
[CasStateMachineDTMFMax
OnDetectionTime]
Detects digit maximum on time (according to DSP detection
information event) in msec units.
The value must be a positive value. The default is -1 (use value from
CAS state machine).
DTMF Min Detection Time
[CasStateMachineDTMFMin
OnDetectionTime]
Detects digit minimum on time (according to DSP detection
information event) in msec units. The digit time length must be longer
than this value to receive a detection. Any number may be used, but
the value must be less than
CasStateMachineDTMFMaxOnDetectionTime.
The value must be a positive value. The default is -1 (use value from
CAS state machine).
MAX Incoming Address Digits
[CasStateMachineMaxNumO
fIncomingAddressDigits]
Defines the limitation for the maximum address digits that need to be
collected. After reaching this number of digits, the collection of
address digits is stopped.
The value must be an integer. The default is -1 (use value from CAS
state machine).
MAX Incoming ANI Digits
[CasStateMachineMaxNumO
fIncomingANIDigits]
Defines the limitation for the maximum ANI digits that need to be
collected. After reaching this number of digits, the collection of ANI
digits is stopped.
The value must be an integer. The default is -1 (use value from CAS
state machine).
Collet ANI
[CasStateMachineCollectAN
I]
In some cases, when the state machine handles the ANI collection
(not related to MFCR2), you can control the state machine to collect
ANI or discard ANI.
ï‚§ [0] No = Don't collect ANI.
ï‚§ [1] Yes = Collect ANI.
ï‚§
Default = Default value - use value from CAS state machine.
Digit Signaling System
[CasStateMachineDigitSigna
lingSystem]
Defines which Signaling System to use in both directions
(detection\generation).
ï‚§ [0] DTMF = Uses DTMF signaling.
ï‚§ [1] MF = Uses MF signaling (default).
ï‚§
Default = Default value - use value from CAS state machine.