Version 7.0 453 Mediant 3000
User's Manual 22. Digital PSTN
• TimeBetweenDigits: Defines the maximum time (in seconds) that the device waits
between digits received from the IP side. When the time expires, the device uses
the collected digits to dial the called destination number.
Note: For IP-to-Tel overlap dialing, to send ISDN Setup messages without including
the Sending Complete IE, you must configure the ISDNOutCallsBehavior parameter
to USER SENDING COMPLETE [2].
For more information on the above mentioned parameters, see PSTN Parameters on page
962. For configuring ISDN overlap dialing using the Web interface, see ''Configuring Trunk
Settings'' on page 429.
To Next Page
Loading...
Need help?
General
