User's Manual 480 Document #: LTRT-89730
Mediant 3000
Notes:
• If the device copies the received destination number to the outgoing SIP redirect
number (enabled by the CopyDest2RedirectNumber parameter), no redirect
number Tel-to-IP manipulation is done.
• The manipulation rules are done in the following order: Stripped Digits From Left,
Stripped Digits From Right, Number of Digits to Leave, Prefix to Add, and then
Suffix to Add.
• The device uses the 'Redirect Prefix' parameter before it manipulates the prefix.
The following procedure describes how to configure redirect number manipulation rules
through the Web interface. You can also configure these rules using the following
management tools:
Redirect Number IP to Tel table: ini file (RedirectNumberMapIp2Tel)
Redirect Number Tel to IP table: ini file (RedirectNumberMapTel2Ip)
To configure a redirect number manipulation rule:
1. Open the redirect number manipulation table (Configuration tab > VoIP menu >
Gateway > Manipulations > Redirect Number Tel > IP or Redirect Number IP >
Tel).
2. Click Add; the following dialog box appears (e.g., Redirect Number Tel-to-IP table):
Figure 24-4: Redirect Number Manipulation Table (Example) - Add Row Dialog Box
3. Configure a manipulation rule according to the parameters described in the table
below.
4. Click Add.
Table 24-4: Redirect Number Manipulation Tables Parameter Description
Parameter Description
Index
[_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Name Defines an arbitrary name to easily identify the row.
To Next Page
Loading...
Need help?
General
