AudioCodes Mediant 3000 User Manual

Version 7.0 781 Mediant 3000
User's Manual 52. Reporting Information to External Party
Notes:
• You can customize the default CDR fields if desired. For customizing Gateway-
related CDRs, see Customizing CDRs for Gateway Calls on page 772. For
customizing SBC-related CDRs, see Customizing CDRs for SBC Calls on page
775.
• To configure the address of the RADIUS Accounting server, see ''Configuring
RADIUS Servers'' on page 238.
 To configure RADIUS accounting:
1. Open the RADIUS Parameters page (Configuration tab > VoIP menu > SIP
Definitions > RADIUS Parameters Settings).
Figure 52-11: RADIUS Accounting Parameters Page
2. Set the 'Enable RADIUS Access Control' parameter to Enable.
3. Configure the remaining parameters as required. For a description of these
parameters, see ''RADIUS Parameters'' on page 1054.
4. Click Submit.
5. For your settings to take effect, reset the device with a flash burn.
The table below lists the RADIUS Accounting CDR attributes included in the
communication packets transmitted between the device and a RADIUS server.
Table 52-5: Supported RADIUS Accounting CDR Attributes
Attribute
ID
Attribute
Name
Vendor-
Specific
Attribute
(VSA) ID
Description
Value
Format
Example AAA
Request Attributes
1 user-name (Standard) Account number or
calling party number
or blank
String up
to 15
digits
long
5421385747 Start Acc
Stop Acc
4 nas-ip-
address
(Standard) IP address of the
requesting device
Numeric 192.168.14.
43
Start Acc
Stop Acc
6 service-type (Standard) Type of service
requested
Numeric 1: login Start Acc
Stop Acc
26 h323-
incoming-
conf-id
1 SIP call identifier Up to 32
octets
h323-
incoming-
conf-
id=3839353
0
Start Acc
Stop Acc
26 h323-remote-
address
23 IP address of the
remote gateway
Numeric - Stop Acc
26 h323-conf-id 24 H.323/SIP call Up to 32 Start Acc

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English