AudioCodes Mediant 3000 User Manual

User's Manual 792 Document #: LTRT-89730
Mediant 3000
Parameter Description
configure the parameter to either "2" or "SIP Trunk" (without
apostrophes).
 For IP trace expressions, see ''Filtering IP Network Traces'' on page
793.
Log Destination
log-dest
[LoggingFilters_Log
Destination]
Defines where the device sends the log file.
 [0] Syslog Server = The device generates Syslog messages based on
the configured log filter and sends them to a user-
defined Syslog server.
The Syslog messages can contain one of the following types of
information, depending on the settings of the 'Log Type' parameter
(described later in the table):

Not configured (default): The Syslog messages contain the regular
syslog information.

CDR Only: The Syslog messages contain only CDRs (no system
information and alerts).
 [1] Debug Recording Server = (Default) The device generates DR
packets based on the configured log filter and sends them to a user-
defined Debug Recording server.
Notes:
 If the 'Filter Type' parameter is configured to IP Trace, you must
configure the parameter to Debug Recording Server.
 If you configure the parameter to Syslog Server and the debug level
(GwDebugLevel) is configured to No Debug (see ''Configuring Syslog
Debug Level'' on page 801), the Syslog messages include only system
Warnings and Errors.
Log Type
log-type
[LoggingFilters_Capt
ureType]
Defines the type of messages to include in the log file.
 [0] = (Default) Not configured. The option is applicable only for sending
Syslog messages to a Syslog server (i.e., 'Log Destination' parameter is
configured to Syslog Server).
 [1] Signaling = The option is applicable only for DR (i.e., 'Log
Destination' parameter is configured to Debug Recording Server). The
DR includes signaling information such as SIP signaling messages,
Syslog messages, CDRs, and the device's internal processing
messages.
 [2] Signaling & Media = The option is applicable only for DR (i.e., 'Log
Destination' parameter is configured to Debug Recording Server). The
DR includes signaling, Syslog messages, and media (RTP/RTCP/T.38).
 [3] Signaling & Media & PCM = The option is applicable only for DR
(i.e., 'Log Destination' parameter is configured to Debug Recording
Server). The DR includes signaling, Syslog messages, media, and
PCM (voice signals from and to TDM).
 [4] PSTN Trace = The option is applicable only for DR (i.e., 'Log
Destination' parameter is configured to Debug Recording Server) and
if the 'Filter Type' parameter is configured to Trunk ID. The DR includes
ISDN and CAS traces.
 [5] CDR Only = Only CDRs are generated. The option is applicable only
if the 'Log Destination' parameter is configured to Syslog Server. When
configured to Syslog Server, only CDRs are included in the Syslog
messages (excluding all system logs and alerts) sent to the Syslog
server.
Notes:
 The parameter is not applicable when the 'Filter Type' parameter is
configured to IP Trace.

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English