AudioCodes Mediant 3000

Version 7.0 885 Mediant 3000
User's Manual 58. Configuration Parameters Reference
Parameter Description
Proxy Address Table
Proxy IP Table
[ProxyIP]
The table defines proxy addresses per Proxy Set.
The format of the ini file table parameter is as follows:
[ProxyIP]
FORMAT ProxyIp_Index = ProxyIp_ProxySetId, ProxyIp_ProxyIpIndex,
ProxyIp_IpAddress, ProxyIp_TransportType;
[\ProxyIP]
For a description of the table, see ''Configuring Proxy Sets'' on page 355
.
Proxy Sets Table
Proxy Set Table
[ProxySet]
Defines the Proxy Sets.
The format of the ini file table parameter is as follows:
[ ProxySet ]
FORMAT ProxySet_Index = ProxySet_ProxyName,
ProxySet_EnableProxyKeepAlive, ProxySet_ProxyKeepAliveTime,
ProxySet_ProxyLoadBalancingMethod, ProxySet_IsProxyHotSwap,
ProxySet_SRDName, ProxySet_ClassificationInput,
ProxySet_TLSContextName, ProxySet_ProxyRedundancyMode,
ProxySet_DNSResolveMethod, ProxySet_KeepAliveFailureResp,
ProxySet_GWIPv4SIPInterfaceName,
ProxySet_SBCIPv4SIPInterfaceName,
ProxySet_SASIPv4SIPInterfaceName,
ProxySet_GWIPv6SIPInterfaceName,
ProxySet_SBCIPv6SIPInterfaceName,
ProxySet_SASIPv6SIPInterfaceName;
[ \ProxySet ]
For a description of the table, see ''Configuring Proxy Sets'' on page 355.
Registrar Parameters
Enable Registration
[IsRegisterNeeded]
Enables the device to register to a Proxy/Registrar server.
 [0] Disable = (Default) The device doesn't register to Proxy/Registrar
server.
 [1] Enable = The device registers to Proxy/Registrar server when the
device is powered up and at every user-defined interval (configured
by the parameter RegistrationTime).
Notes:
 The parameter is applicable only to the Gateway application.
 The device sends a REGISTER request for each channel or for the
entire device (according to the AuthenticationMode parameter).
Registrar Name
[RegistrarName]
Defines the Registrar domain name. If specified, the na
me is used as the
Request-URI in REGISTER messages. If it isn't specified (default), the
Registrar IP address, or Proxy name or IP address is used instead.
The valid range is up to 100 characters.
Note: The parameter is applicable only to the Gateway application.
Registrar IP Address
[RegistrarIP]
Defines the IP address (or FQDN) and port number (optional) of the
Registrar server. The IP address is in dotted-decimal notation, e.g.,
201.10.8.1:<5080>.
Notes:

The parameter is applicable only to the Gateway application.