AudioCodes Mediant 3000 User Manual

Version 7.0 887 Mediant 3000
User's Manual 58. Configuration Parameters Reference
Parameter Description
Registration Time
Threshold
[RegistrationTimeThreshol
d]
Defines a threshold (in seconds) for re-registration timing. If the
parameter is greater than 0, but lower than the computed re-registration
timing (according to the parameter RegistrationTimeDivider), the re-
registration timing is set to the following: timing set by the Registration
server in the SIP Expires header minus the value of the parameter
RegistrationTimeThreshold.
The valid range is 0 to 2,000,000. The default is 0.
Re-register On INVITE
Failure
[RegisterOnInviteFailure]
Enables immediate re-registration if no response is received for an
INVITE request sent by the device.
 [0] Disable (default)
 [1] Enable = The device immediately expires its re-registration timer
and commences re-registration to the same Proxy upon any of the
following scenarios:

The response to an INVITE request is 407 (Proxy Authentication
Required) without an authentication header included.

The remote SIP UA abandons a call before the device has
received any provisional response (indicative of an outbound
proxy server failure).

The remote SIP UA abandons a call and the only provisional
response the device has received for the call is 100 Trying
(indicative of a home proxy server failure, i.e., the failure of a
proxy in the route after the outbound proxy).

The device terminates a call due to the expiration of RFC 3261
Timer B or due to the receipt of a 408 (Request Timeout)
response and the device has not received any provisional
response for the call (indicative of an outbound proxy server
failure).

The device terminates a call due to the receipt of a 408 (Request
Timeout) response and the only provisional response the device
has received for the call is the 100 Trying provisional response
(indicative of a home proxy server failure).
Note: The parameter is applicable only to the Gateway application.
ReRegister On
Connection Failure
[ReRegisterOnConnection
Failure]
Enables the device to perform SIP re-registration upon TCP/TLS
connection failure.
 [0] Disable (default)
 [1] Enable
Gateway Registration
Name
[GWRegistrationName]
Defines the user name that is used in the From and To headers in SIP
REGISTER messages. If no value is specified (default) for the
parameter, the UserName parameter is used instead.
Notes:
 The parameter is applicable only to the Gateway application.
 The parameter is applicable only for single registration per device
(i.e., AuthenticationMode is set to 1). When the device registers each
channel separately (i.e., AuthenticationMode is set to 0), the user
name is set to the channel's phone number.
Registration Mode
[AuthenticationMode]
Determines the device's registration and authentication method.
 [0] Per Endpoint = Registration and authentication is performed
separately for each B-channel.

[1] Per Gateway = (Default) Single registration and authentication for

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English