AudioCodes Mediant 3000 User Manual

Version 7.0 915 Mediant 3000
User's Manual 58. Configuration Parameters Reference
Parameter Description
IP-to-Tel calls.
The valid range is 0 to 127. The default is -1 (not configured).
Note: When not configured (i.e., default), the SITQ850Cause parameter
is used.
SIT Q850 Cause For RO
[SITQ850CauseForRO]
Defines the Q.850 cause value specified in the SIP Reason header that
is included in a 4xx response when SIT-RO (Reorder - System Busy
Special Information Tone) is detected from the Tel for IP-to-Tel calls.
The valid range is 0 to 127. The default is -1 (not configured).
Note: When not configured (i.e., default), the SITQ850Cause parameter
is used.
[GWInboundManipulation
Set]
Selects the Manipulation Set ID for manipulating all inbound INVITE
messages. The Manipulation Set is defined using the
MessageManipulations parameter. By default, no manipulation is done
(i.e. Manipulation Set ID is set to -1).
Note: The parameter is applicable only to the Gateway application.
[GWOutboundManipulatio
nSet]
Selects the Manipulation Set ID for manipulating all outbound INVITE
messages. The Manipulation Set is defined using the
MessageManipulations parameter. By default, no manipulation is done
(i.e. Manipulation Set ID is set to -1).
Notes:
 The parameter is used only if the Outbound Message Manipulation
Set parameter of the destination IP Group is not set.
 The parameter is applicable only to the Gateway application.
Out-of-Service (Busy Out) Parameters
Enable Busy Out
[EnableBusyOut]
Enables the Busy Out feature.
 [0] Disable (Default)
 [1] Enable
When Busy Out is enabled and certain scenarios exist, the device does
the following:
 All trunks (E1/T1) are automatically taken out-of-service by taking
down the D-Channel, or for T1 PRI trunks, by sending a Service Out
message supporting these messages (NI-2, 4/5-ESS, DMS-100, and
Meridian).
The above behavior is done upon one of the following scenarios:
 The device is physically disconnected from the network (i.e., Ethernet
cable is disconnected).
 The Ethernet cable is connected, but the device is unable to
communicate with any host. For this scenario, the LAN Watchdog
feature must be activated (i.e., set the EnableLANWatchDog
parameter to 1).
 The device can't communicate with the proxy (according to the Proxy
Keep-Alive mechanism) and no other alternative route exists to send
the call.
 The IP Connectivity mechanism is enabled (using the
AltRoutingTel2IPEnable parameter) and there is no connectivity to
any destination IP address.
Notes:
 The Busy Out behavior depends on the PSTN protocol type.

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English