User's Manual 934 Document #: LTRT-89730
Mediant 3000
Parameter Description

[-1] Not Configured (default)
 [0] UDP
 [1] TCP
 [2] TLS
Notes:
 When set to [-1], the value of the SIPTransportType parameter
is used.
 The parameter is applicable only to the Gateway application.
RTCP XR Collection Server
[RTCPXREscIP]
Defines the IP address of the Event State Compositor (ESC). The
device sends RTCP XR reports to this server, using SIP PUBLISH
messages, according to Internet-Draft draft-ietf-sipping-rtcp-
summary-13. The address can be configured as a numerical IP
address or as a domain name.
Note:
 Instead of sending RTCP XR to an ESC server, you can send
RTCP XR to an IP Group (see the PublicationIPGroupID
parameter).
 This parameter is applicable only to the Gateway application.
Gateway RTCP XR Report
Mode
[RTCPXRReportMode]
Determines whether RTCP XR reports are sent to the Event State
Compositor (ESC) and defines the interval at which they are sent.
 [0] Disable = (Default) RTCP XR reports are not sent.
 [1] End Call = RTCP XR reports are sent at the end of each call.
 [2] End Call & Periodic = RTCP XR reports are sent at the end
of each call and periodically according to the RTCPInterval
parameter.
Note: The parameter is applicable only to the Gateway application.
SBC RTCP XR Report Mode
[SBCRtcpXrReportMode]
Enables the sending of RTCP XR reports of QoE metrics at the end
of each call session (i.e., after a SIP BYE). The RTCP XR is sent in
the SIP PUBLISH message.
 [0] Disable (default)
 [1] End of Call
Note: The parameter is applicable only to the SBC application.
publication-ip-group-id
[PublicationIPGroupID]
Defines the IP Group to where the RTCP XR is sent. If the value is -
1 (default) or 0, the RTCP XR is sent to the ESC server, as
configured by the RTCPXREscIP parameter.
Note: The parameter is applicable only to the Gateway application.
To Next Page
Loading...
Need help?
General
