AudioCodes Mediant 3000

User's Manual 936 Document #: LTRT-89730
Mediant 3000
Parameter Description
[V32ModemTransportType]

[0] Disable = Transparent.
 [2] Enable Bypass (default)
 [3] Events Only = Transparent with Events.
Notes:
 The parameter applies only to V.32 and V.32bis modems.
 You can also configure this functionality per specific calls, using
IP Profiles (IpProfile_VxxTransportType). For more information,
see ''Configuring IP Profiles'' on page 391.
V.34 Modem Transport Type
[V34ModemTransportType]
Determines the V.90/V.34 modem transport type.
 [0] Disable = Transparent.
 [2] Enable Bypass (default)
 [3] Events Only = Transparent with Events.
Note: You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_VxxTransportType). For more
information, see ''Configuring IP Profiles'' on page 391.
[BellModemTransportType]
Determines the Bell modem transport method.
 [0] = Transparent (default)
 [2] = Bypass

[3]
= Transparent with events
Fax CNG Mode
[FaxCNGMode]
Determines the device's handling of fax relay upon detection of a
fax CNG tone or a V.34/Super G3 V8-CM (Call Menu) signal from
originating faxes.
 [0] Doesn't send T.38 Re-INVITE = (Default) SIP re-INVITE is
not sent.
 [1] Sends on CNG tone = Sends a SIP re-INVITE with T.38
parameters in SDP to the terminating fax upon detection of a fax
CNG tone, if the CNGDetectorMode parameter is set to 1.
 [2] Sends on CNG or v8-cn = Sends a SIP re-INVITE with T.38
parameters in SDP to the terminating fax upon detection of a fax
CNG tone (if the CNGDetectorMode parameter is set to 1) or
upon detection of a V8-CM signal.
Notes:
 Option [2] is applicable only if the device is loaded with DSP
template 10 (i.e., DSPVersionTemplateNumber parameter is set
to 10).
 If the parameter is set to [2] and the CNGDetectorMode
parameter is set to [0], the device sends a re-INVITE only if it
detects a V8-CM signal from the originating fax.
 This feature is applicable only if the IsFaxUsed parameter is set
to [1] or [3].
 The device also sends T.38 re-INVITE if the CNGDetectorMode
parameter is set to [2], regardless of the FaxCNGMode
parameter settings.
CNG Detector Mode
[CNGDetectorMode]
Global parameter that enables the detection of the fax calling tone
(CNG) and defines the detection method. You can also configure
this functionality per specific calls, using IP Profiles
(IpProfile_CNGmode). For a detailed description of the parameter
and for configuring this functionality in the IP Profile table, see
''Configuring IP Profiles'' on page 391.
Note: If this functionality is configured for a specific IP Profile, the