Version 7.0 941 Mediant 3000
User's Manual 58. Configuration Parameters Reference
Parameter Description
sending T.38 packets to the terminating fax machine.
Note: To enable No-Op packet transmission, use the NoOpEnable
and NoOpInterval parameters.
V.150.1 Modem over IP
Note: These parameters are applicable only to the Gateway application.
Profile Number
[V1501AllocationProfile]
Defines the V.150.1 profile, which determines how many DSP
channels support V.150.1.
The value range is 0 to 20. The default is 0.
Note: For the parameter to take effect, a device reset is required.
SSE Payload Type Rx
[V1501SSEPayloadTypeRx]
Defines the V.150.1 (modem relay protocol) State Signaling Event
(SSE) payload type Rx.
The value range is 96 to 127. The default is 105.
SSE Redundancy Depth
[V1501SSERedundancyDepth]
Defines the SSE redundancy depth.
The value range is 1-6. The default is 3.
SPRT Transport Ch.0 Max
Payload Size
[V1501SPRTTransportChannel
0MaxPayloadSize]
Defines the maximum payload size for V.150.1 SPRT Transport
Channel 0.
The range is 140 to 256. The default is 140.
SPRT Transport Ch.2 Max
Payload Size
[V1501SPRTTransportChannel
2MaxPayloadSize]
Defines the maximum payload size for V.150.1 SPRT Transport
Channel 2.
The range is 132 to 256. The default is 132.
SPRT Transport Ch.2 Max
Window Size
[V1501SPRTTransportChannel
2MaxWindowSize]
Defines the maximum window size of SPRT transport channel 2.
The value range is 8 to 32. The default is 8.
SPRT Transport Ch.3 Max
Payload Size
[V1501SPRTTransportChannel
3MaxPayloadSize]
Defines the maximum payload size for V.150.1 SPRT Transport
Channel 3.
The range is 140 to 256. The default is 140.
To Next Page
Loading...
Need help?
General
