AudioCodes Mediant 3000 User Manual

Version 7.0 943 Mediant 3000
User's Manual 58. Configuration Parameters Reference
Parameter Description
nt]

[1] = (Default) DTMF event is reported at the start of a detected
DTMF digit.
Declare RFC 2833 in SDP
[RxDTMFOption]
Global parameter that enables the device to declare the RFC 2833
'telephony-event' parameter in the SDP. You can also configure this
functionality per specific calls, using IP Profiles
(IpProfile_RxDTMFOption). For a detailed description of the parameter
and for configuring this functionality in the IP Profile table, see
''Configuring IP Profiles'' on page 391.
Note: If this functionality is configured for a specific IP Profile, the
settings of this global parameter is ignored for calls associated with the
IP Profile.
First Tx DTMF Option
[FirstTxDTMFOption]
Defines the first preferred transmit (Tx) DTMF negotiation method.
 [0] Not Supported = (Default) No negotiation - DTMF digits are sent
according to the parameters DTMFTransportType and
RFC2833PayloadType. The RFC 2833 payload type is according to
the RFC2833PayloadType parameter for transmit and receive.
 [1] Info NORTEL = Sends DTMF digits according to IETF Internet-
Draft draft-choudhuri-sip-info-digit-00.
 [2] NOTIFY = Sends DTMF digits according to IETF Internet-Draft
draft-mahy-sipping-signaled-digits-01.
 [3] Info Cisco = Sends DTMF digits according to Cisco format.
 [4] RFC 2833 = The device handles DTMF as follows:

Negotiates RFC 2833 payload type using local and remote
SDPs.

Sends DTMF packets using RFC 2833 payload type according
to the payload type in the received SDP.

Expects to receive RFC 2833 packets with the same payload
type according to the RFC2833PayloadType parameter.

Removes DTMF digits in transparent mode (as part of the voice
stream).
 [5] Info KOREA = Sends DTMF digits according to Korea Telecom
format.
Notes:
 When out-of-band DTMF transfer is used ([1], [2], [3], or [5]), the
DTMFTransportType parameter is automatically set to [0] (DTMF
digits are erased from the RTP stream).
 For more information on DTMF transport, see ''Configuring DTMF
Transport Types'' on page 213.
 You can also configure the parameter per specific calls, using IP
Profiles (IpProfile_FirstTxDtmfOption). For configuring IP Profiles,
see ''Configuring IP Profiles'' on page 391.
Second Tx DTMF Option
[SecondTxDTMFOption]
Defines the second preferred transmit (Tx) DTMF negotiation method.
The first preferred method is configured by the FirstTxDTMFOption
parameter. For a description of the optional values for the parameter,
see the FirstTxDTMFOption parameter above.
Note: You can also configure the parameter per specific calls, using IP
Profiles (IpProfile_SecondTxDtmfOption). For configuring IP Profiles,
see ''Configuring IP Profiles'' on page 391.
[DisableAutoDTMFMute] Enables the automatic muting of DTMF digits when out-of-band DTMF
transmission is used.

AudioCodes Mediant 3000 Specifications

General

Brand	AudioCodes
Model	Mediant 3000
Category	Gateway
Language	English