AudioCodes Mediant 3000

Version 7.0 963 Mediant 3000
User's Manual 58. Configuration Parameters Reference
Parameter Description

[10] T1 NI2 ISDN = National ISDN 2 PRI protocol
 [11] T1 4ESS ISDN = ISDN PRI protocol for the
Lucent™/AT&T™ 4ESS switch.
 [12] T1 5ESS 9 ISDN = ISDN PRI protocol for the
Lucent™/AT&T™ 5ESS-9 switch.
 [13] T1 5ESS 10 ISDN = ISDN PRI protocol for the
Lucent™/AT&T™ 5ESS-10 switch.
 [14] T1 DMS100 ISDN = ISDN PRI protocol for the Nortel™
DMS switch.
 [15] J1 TRANSPARENT
 [16] T1 NTT ISDN = ISDN PRI protocol for the Japan - Nippon
Telegraph Telephone (known also as INS 1500).
 [17] E1 AUSTEL ISDN = ISDN PRI protocol for the Australian
Telecom.
 [18] E1 HKT ISDN = ISDN PRI (E1) protocol for the Hong Kong
- HKT.
 [19] E1 KOR ISDN = ISDN PRI protocol for Korean Operator
(similar to ETSI).
 [20] T1 HKT ISDN = ISDN PRI (T1) protocol for the Hong Kong
- HKT.
 [21] E1 QSIG = ECMA 143 QSIG over E1
 [22] E1 TNZ = ISDN PRI protocol for Telecom New Zealand
(similar to ETSI)
 [23] T1 QSIG = ECMA 143 QSIG over T1
 [30] E1 FRENCH VN6 ISDN = France Telecom VN6
 [31] E1 FRENCH VN3 ISDN = France Telecom VN3
 [34] T1 EURO ISDN =ISDN PRI protocol for Euro over T1
 [35] T1 DMS100 Meridian ISDN = ISDN PRI protocol for the
Nortel™ DMS Meridian switch
 [36] T1 NI1 ISDN = National ISDN 1 PRI protocol
 [40] E1 NI2 ISDN = National ISDN 2 PRI protocol over E1
Note: All PRI trunks must be configured as the same line type
(either E1 or T1). The device can support different variants of CAS
and PRI protocols on different E1/T1 spans (no more than four
simultaneous PRI variants).
[ProtocolType_x] Defines the protocol type for a specific trunk ID (where x denotes
the Trunk ID and 0 is the first trunk). For more information, see the
ProtocolType parameter.