Version 7.0 979 Mediant 3000
User's Manual 58. Configuration Parameters Reference
Parameter Description
set (default behavior), CC implements the UUI-protocol as
specified in the ETS 300-403 standards for Implicit Service 1.
 [65536] GTD5 TBCT = CC implements the VERIZON-GTD-5
Switch variant of the TBCT Supplementary Service, as specified
in FSD 01-02-40AG Feature Specification Document from
Verizon. Otherwise, TBCT is implemented as specified in GR-
2865-CORE specification (default behavior).
Note: When using the ini file to configure the device to support
several ISDNGeneralCCBehavior features, add the individual
feature values. For example, to support both [16] and [32] features,
set ISDNGeneralCCBehavior = 48 (i.e., 16 + 32).
Outgoing Calls Behavior
[ISDNOutCallsBehavior]
Determines several behaviour options (bit fields) that influence the
behaviour of the ISDN Stack outgoing calls. To select options, click
the arrow button, and then for each required option, select 1 to
enable. The default is 0 (i.e., disable).
 [2] USER SENDING COMPLETE =The default behavior of the
device (when this bit is not set) is to automatically generate the
Sending-Complete IE in the Setup message. This behavior is
used when overlap dialing is not needed. When overlap dialing
is needed, set this bit and the behavior is changed to suit the
scenario, i.e., Sending-Complete IE is added when required in
the Setup message for Enblock mode or in the last Digit with
Overlap mode.
 [16] USE MU LAW = The device sends G.711-m-Law in
outgoing voice calls. When disabled, the device sends G.711-A-
Law in outgoing voice calls.
Note: This option is applicable only to the Korean variant.
 [128] DIAL WITH KEYPAD = The device uses the Keypad IE to
store the called number digits instead of the CALLED_NB IE.
Note: This option is applicable only to the Korean variant
(Korean network). This is useful for Korean switches that don't
accept the CALLED_NB IE.
 [256] STORE CHAN ID IN SETUP = The device forces the
sending of a Channel-Id IE in an outgoing Setup message even
if it's not required by the standard (i.e., optional) and no
Channel-Id has been specified in the establishment request.
This is useful for improving required compatibility with switches.
On PRI lines it indicates an unused channel ID, preferred only.
 [512] USE A LAW = The device sends G.711 A-Law in outgoing
voice calls. When disabled, the device sends the default G.711-
Law in outgoing voice calls.
Note: This option is applicable only to the E10 variant.
 [1024] = Numbering plan/type for T1 IP-to-Tel calling numbers
are defined according to the manipulation tables or according to
the RPID header (default). Otherwise, the plan/type for T1 calls
are set according to the length of the calling number.
 [2048] = The device accepts any IA5 character in the called_nb
and calling_nb strings and sends any IA5 character in the
called_nb, and is not restricted to extended digits only (i.e., 0-
9,*,#).
 [16384] DLCI REVERSED OPTION = Behavior bit used in the
IUA interface groups to indicate that the reversed format of the
DLCI field must be used.
To Next Page
Loading...
Need help?
General
