AudioCodes Mediant 800 Reference Guide

CHAPTER7 SNMP Traps
Mediant 800 SBC | SNMP Reference Guide
Alarm acHASystemFaultAlarm
"Switch-Over:
Reason =
Network
Monitor error.
Failed table rows
index: <id 1> …
up to <id 10>"
HA was lost due to
switchover due to the HA
Network Monitor feature as
the threshold of
unreachable rows (in the HA
Network Monitor table) was
exceeded. The indices of
these unreachable rows are
provided in the alarm's text.
The HA mode should return
automatically after a few
minutes. No corrective
action is required.
"Switch-Over:
Reason = Keep
Alive error"
HA was lost due to
switchover and should
return automatically after a
few minutes. Corrective
action is not required.
"Switch-Over:
Reason = DSP
error"
HA was lost due to
switchover and should
return automatically after a
few minutes. Corrective
action is not required.
Note: Applicable only to
Mediant 4000.
"Switch-Over:
Reason =
Software
upgrade"
HA was lost due to
switchover and should
return automatically after a
few minutes. Corrective
action is not required.
"Switch-Over:
Reason =
Software
upgrade - switch
back"
HA was lost due to
switchover (Hitless Software
Upgrade process switched
from the active to
redundant device) and
should soon return
automatically. Corrective
action is not required.
"Switch-Over: HA was lost due to
- 108 -

AudioCodes Mediant 800 Specifications

General

Protocols	SIP, H.323
Digital Interfaces	1/2 E1/T1 PRI
Management	Web, CLI, SNMP
Mounting	19-inch rack
Codecs	G.711, G.729, G.722, G.723.1
Power Supply	100-240V AC
Operating Temperature	0 to 40°C
Storage Temperature	-25 to 70°C
Humidity	10% to 90% non-condensing