723–0018 /02 F7010
1.1 Scope and limitations
Scope
This document is intended to describe fault resolution, low frequency maintenance and parts replacement
procedures for the Barco F70. Only partners named in service agreement with Barco Fredrikstad AS may
carry out procedures detailed in this document. Information contained herein is subject to change without
further notice; please refer to online documentation for updated information.
1.2 Copyright
Copyright
All rights reserved. No part of this document may be copied, reproduced or translated. It shall not otherwise be
recorded, transmitted or stored in a retrieval system without prior written consent of Barco.
1.3 Trademarks
Trademarks
Brands and product names mentioned in this manual may be trademarks, registered trademarks or copyrights
of their respective holders. All brands and product names mentioned in this manual serve as comments or
examples and are not to be understood as advertising for the product or their manufacturers.
1.4 Required Handtools
Required Handtools
The following tools are needed for servicing the unit:
• Screwdriver,s, Torx6, 8, 10, 20.
• Allen Key, Size 1.5, 2, 3, 5mm
• Scalpel
• Screwdriver, Flat head 4mm
• Ionized pressurized air for cleaning optical components
• Adjustable thermal heater for releasing Cooling system.
• Suitable cleaner for thermal transfer compound, (Brake / clutch cleaner). Isopropanol can be used, but are
not as powerful as brake cleaner.
Unless otherwise indicated in the procedure, screw torque to be applied is 0.3 Nm.
Introduction
To Next Page
Loading...
