Accessories
100 Progressa+ Bed Instructions for Use (216321 REV 2)
Caution—To help prevent equipment damage, obey these cautions:
• Caution—Use caution when you move the bed through doorways. Equipment damage could
occur.
• Caution—Use caution when you adjust the bed height. Make sure that the bed will not hit the
overhead lights and doorways.
• Caution—Use caution when you use trend and reverse trend. Make sure the bed will not hit the
headwall system or other equipment.
Make sure to put the overhead arm in the transport position to transport the bed, see Step 4 on
page 102.
The USB port is not designed for devices that require less than 170 mA of power such as USB reading
lights, but supports up to 2.4 A of current.
To Install
With the Experience Pod Device, you can—
• Charge the PED
• Put your PED in the PED holder (see above for the PED
dimensions supported)
• Store the PED charging cord
• Adjust the Experience Pod Device for optimal use
1. Make sure the bed’s brake is set, and a patient is not in the
bed.
2. Raise the bed to access underneath the head section.
Make sure the Experience Pod Device is in the transport position
before installing, see
Step 4 on page 102.
3. Remove the pin from the Experience Pod Device.
To Next Page
Loading...
