Accessories
Progressa+ Bed Instructions for Use (216321 REV 2) 101
To Remove
4. Install the Experience Pod Device into the accessory socket
at the head end of the bed. Make sure the arm assembly is
fully inserted into the socket.
Warning—Make sure that the arm is correctly attached in step 4. Otherwise, it may fall. Injury or
equipment damage could occur.
5. From underneath the head end of the bed frame, insert the
pin to hold the Experience Pod Device in position.
6. Install the retainer on to the pin.
7. Make sure the pin is through the retainer.
8. Make sure the power cord is connected to the Experience
Pod Device.
Do not power the Experience Pod Device by the auxiliary outlet.
9. Plug the Experience Pod Device power cord into AC power.
10. If applicable, plug in the bed power cord.
11. Lower the bed to its lowest position.
1. Make sure the bed’s brake is set, and a patient is not in the
bed.
2. Raise the bed to access underneath the head section.
3. Unplug the Experience Pod Device power cord from AC power.
To Next Page
Loading...
