BD FACSCanto II - Adding Tubes to an Existing Carousel; Re-Running a Carousel; Stopping a Run

144 BD FACSCanto II Instructions for Use
Adding Tubes to an Existing Carousel
1 In the current experiment, add a specimen.
2 Choose Carousel > Carousel Setup.
3 Delete the Carousel break.
The Carousel ID is automatically assigned to the new specimen in the
worklist.
4 Click Run Carousel in Carousel Controls.
5 In the re-run dialog that appears, select the new tubes or specimen; click
OK to close the dialog.
Re-running a Carousel
1 After all tubes in the carousel are recorded, click Run Carousel in Carousel
Controls.
2 In the dialog that appears, select all tubes in the carousel; click OK to close
the dialog.
The run begins.
Stopping a Run
To stop a carousel, click in Carousel Controls. The run stops and
the Carousel Report appears.