Chapter 6: Running Samples with BD FACSCanto Clinical Software 99
If this happens, click , and unload the tube. Wait for the Load
Tube message before you install the next tube.
NOTICE To prevent backflow into the tube, follow the tube removal
sequence exactly. For more information, see Cytometer
Troubleshooting on page 190.
14 (Manual) Repeat steps 7 through 11 until there are no more samples.
15 (Loader) Load the next carousel when prompted, and click .
16 After all samples have been run, review the worklist.
17 After the last run of the day, shut down the system.
See Chapter 9 on page 147, for instructions.
Options During Acquisition
Do any of the following during acquisition:
• Adjust voltages, thresholds, and spectral overlap values. See Optimizing
During a Run (page 100).
• Inspect recorded data on the Lab Report (page 101).
• Skip tubes or samples (page 106).
• Stop recording and acquisition (page 106).
• Add samples to a worklist (page 106).
To Next Page
Loading...
