98 BD FACSCanto II Instructions for Use
13 (Manual) After data has been recorded for the first tube, remove the tube at
the prompt and install the next tube.
• Hold your sample tube while you push the aspirator arm to the left.
• Remove the tube from the SIT.
• Release the aspirator arm.
SIT cleaning occurs when the aspirator arm comes to center. When
cleaning is finished, you are prompted to load the next tube.
NOTICE If you do not unload a tube when prompted, the following
message appears.
If you move the arm without holding the tube, the tube could fall off the
SIT and expose you to potentially biohazardous sample.
To Next Page
Loading...
