Chapter 2: BD FACSDiva Software Overview 37
Compensation Controls
You can create label-specific compensation controls. Refer to the BD FACSDiva
Software Reference Manual for information.
Throughput Mode
The default mode at startup is high
throughput. Select throughput mode by
clicking the corresponding mode button in the Setup view. You can also select
throughput mode in the Plate Inspector.
Default acquisition settings and limits change when you switch between standard
and high throughput mode, so choose the mode first when setting up a plate.
NOTICE The throughput mode applies to the entire plate, so all wells on the
plate are acquired in the same mode, except for setup and compensation control
wells, which are always run in standard mode.
The following acquisition times can be achieved with the settings specified in
Table 1-1 on page 14.
• In high throughput mode, the HTS can process a 96-well plate in
approximately 15 minutes.
• In standard mode, the HTS can process a 96-well plate in approximately
44 minutes.
For details on how the HTS acquires samples in each mode, see Sample
Processing on page 23.
Loader Status
Monitor status messages for the HTS Loader during acquisition by viewing the
Loader status field. For Loader errors, see HTS Troubleshooting on page 146.
To Next Page
Loading...
