About the device Operating instructions CS 300
2 - 8 6.110.98.5.01.40 en
2
If the mains power supply is subject to electric interference, interference suppression
measures must be taken on site, e.g.:
–
provision of separate mains line to our devices.
– In case of problems, insertion of capacitively decoupled isolating transformers or oth-
er suppressors into the mains supply lines to Bizerba device.
2.8 Warranty
Installation, commissioning and initial training must be carried out by trained Bizerba sales
office or customer service personnel, or by companies commissioned by Bizerba.
Bizerba is not responsible for damages caused by:
–
non-observance of operating conditions and operating instructions.
– defective electrical installation by the customer.
– structural changes to the devices.
– removal of verification seals and safety stamp marks.
– incorrect programming and operation.
– natural wear and tear.
The warranty will lapse, if:
– defects/damages occur as a result of interventions by persons not authorized by Bi-
zerba.
– any spare parts or operating material other than original Bizerba ones are used.
– any thermal ticket rolls and labels other than original Bizerba ones are used.
– Labels and thermal ticket rolls are used, which have not been manufactured to Bizer-
ba specification or approved by Bizerba.
If you reset or program devices, check the new setting with a test run and test printout.
This helps to avoid incorrect results.
Only trained staff may operate the devices.
Check that Bizerba products are handled correctly and repeat training if necessary.
Bizerba products undergo continuous further development and are subject to different
country-specific regulations. Examples of pictures and graphics contained in these operat-
ing instructions may vary from the version which you received.
2.9 Disposal of devices/environmental protection
Only valid for Germany!
Batteries are fitted in this device which are subject to the Battery Ordinance on the return
and disposal of used batteries.
This ordinance requires you, as the end user, to return the device to the manufacturer or
dealer, at the end of its proper use, for the purposes of recycling and correct disposal.
To Next Page
Loading...
