Operating instructions CS 300 Installation
6.110.98.5.01.40 en 4 - 3
4
4.2.2 Mains supply
WARNING Incorrect supply voltage!
The consequences can be:
Destruction of electric components, fire hazard.
– Compare the data of the supply voltage with the specifications on
the device identification plate.
–
Do not connect the device to the electric mains if the data of the
supply voltage do not match the connection values of the device.
– Inform Bizerba Customer Service
Bizerba devices are built according to VDE protection (extra-low voltage) and must be
connected to a plug-in power supply unit with extra-low voltage.
This product is to be power-supplied via a listed plug-in transformer unit
with identification class 2 and the electric nominal values 9V DC,
500mA.
4.2.3 Installation between Bizerba devices and devices from other
manufacturers
Installation must be carried out by a specialist and is usually done by the Bizerba service.
4.3 Start-up
Putting into operation, as well as instruction on the operation, cleaning, maintenance and
servicing is carried out by the relevant Bizerba customer services office or the Bizerba
trade consultant.
4.3.1 Switching on device
Requirement:
– The device has been installed properly and connected to the mains power supply.
– The scale must not be loaded.
Switch on device.
To Next Page
Loading...
