Bizerba CS 300 - Default Chapter; Table of Contents

Operating instructions CS 300 Contents
6.110.98.5.01.40 en 0 - 1
Contents Page
1 About these instructions ............................................ 1 - 1
1.1 Safe-keeping ................................................ 1 - 1
1.2 Target group ................................................. 1 - 1
1.3 Additional applicable documents ............................... 1 - 1
1.4 Symbols used ................................................ 1 - 2
1.5 Warnings .................................................... 1 - 3
2 About the device ................................................... 2 - 1
2.1 Device types ................................................. 2 - 1
2.2 Accessories .................................................. 2 - 2
2.3 Intended use ................................................. 2 - 2
2.4 Identification plate ............................................ 2 - 2
2.5 Verification-related notes ...................................... 2 - 4
2.6 Standards and guidelines ..................................... 2 - 6
2.7 Operating conditions .......................................... 2 - 7
2.7.1 Power supply ................................................ 2 - 7
2.8 Warranty .................................................... 2 - 8
2.9 Disposal of devices/environmental protection ................... 2 - 8
3 Safety instructions ................................................. 3 - 1
3.1 Requirements for operating personnel ......................... 3 - 1
3.2 System-related sources of hazards ............................ 3 - 1
3.3 Plates on the device .......................................... 3 - 2
4 Installation ......................................................... 4 - 1
4.1 Transport and storage ........................................ 4 - 1
4.2 Installation and assembly ..................................... 4 - 2
4.2.1 Requirements on place of installation .......................... 4 - 2
4.2.2 Mains supply ................................................. 4 - 3
4.2.3 Installation between Bizerba devices and devices from other man-
ufacturers .................................................... 4 - 3
4.3 Start-up ..................................................... 4 - 3
4.3.1 Switching on device .......................................... 4 - 3
4.3.2 Checking the scale for freedom of movement ................... 4 - 4
4.4 Decommissioning ............................................ 4 - 5