About the device Operating instructions CS 300
2 - 4 6.110.98.5.01.40 en
2
14 Scale accuracy class III
15 Min 40 g Minimum load 40 g
16 Max 6/15 kg Maximum load
0-6 kg first interval range
6-15 kg second interval range
17 Nr./No. Device no.
2.5 Verification-related notes
Note related to scales that have been used in Germany since
1/1/2015.
If new or refurbished devices [...] are used, they need to be registered
at the notified authority according to state law, at latest six weeks after
setting into operation.
This, however, is not mandatory for accessory components.
Metrological / verification information for EC countries
On the identification plate of the scale there is the green (metrology mark). This type of
scale can be commissioned and used in-situ, providing that it is not connected to an addi-
tional set-up (e.g. printer).
Scales that are connected on site to an additional device must have the conformity valua-
tion carried out either by the responsible verification office or by a Bizerba verification engi-
neer. Scales as well as the additional device must be tested and verified. If the scale with
add. device meets the verification-related requirements, it can be used in operations that
are subject to verification. In the case of extensions at a later date, once the scales have
already been put into operation, the relevant verification office must be informed.
Scales and additional devices not bearing the EC mark and without any mark of conformity
may not be used in transactions subject to verification.
Scales that have been adjusted to a certain gravity zone (gravitational acceleration) (see
data on identification plate), must not be applied in other gravity zones without being ad-
justed and verified accordingly.
According to statutory regulations, the user of a scale must ensure that it is used for its
intended purpose. This includes observation of the verification guidelines, in particular
amendments, supplements and additions.
To Next Page
Loading...
