Bizerba CS 300 - Tare functions

Operation Operating instructions CS 300
6 - 2 6.110.98.5.01.40 en
6
If the weight value display is not zero with the scale being unloaded, it can be reset to
zero.
Press key <0> once.
The weight display is set to zero.
6.4 Tare functions
Tare balancing for unknown tare values
An unknown tare (empties) is a non product-related tare, which must be
weighed and tared.
–
For scales with weighing ranges of up to 10 kg, the entire weighing
range can be tared.
– For scales with a weighing range above 10 kg, taring of up to 9.995
kg max (max. 4 digits) is possible (depending on country).
– The tared value is subtracted from the total weighing range.
– The tare command is only directly executed when the weight dis-
play is stationary.
6.4.1 Taring with unknown tare
Weigh article in an empty container (tare) whose weight is unknown.
Fig. 76: Weight display
Place the empty container on the scale.
The weight display
1
indicates the
weight of the empty container, e.g.:
"0.535" kg.
Fig. 77: Tare display
Press the <T> key.
The tare display
2
indicates the weight
of the empty container "0.535" kg.
The weight display
1
indicates zero.