Bizerba CS 300 - Mounting the Weighing System

Installation Operating instructions CS 300
4 - 20 6.110.98.5.01.40 en
4
Remove another load platter holder
1
from
the top of the scanner head
3
. Use a suita-
ble screwdriver
2
(currently: Torx TX10,
subject to change).
Fig. 34: Remove further load platter holder
Weighing system
The weighing system was preset and verified during manufacture. It is conform with the
verification regulation.
The weighing system CS 300 MA 94 is firstly mounted to the scanner by the POS or scan-
ner supplier and then installed into the POS counter on site.
Mounting the weighing system
The scanner must not be connected.
–
Unplug scanner.
– Please observe the scanner operating instructions .
CAUTION Incorrect use of weighing system!
Damage of weighing system.
–
Do not lift the weighing system at the load arms.
1
Load arms
2
Weighing system
Fig. 35: Load arms MA 94