Operating instructions CS 300 Safety instructions
6.110.98.5.01.40 en 3 - 1
3
3 Safety instructions
The safety instructions must be observed throughout the installation, operation, cleaning
and maintenance procedures.
3.1 Requirements for operating personnel
The device must only be operated by personnel trained in the operation of this equipment.
The operating personnel must read and understand the safety instructions in these operat-
ing instructions.
Please pay special attention to and memorize all safety and hazard information! Carry out
regular training!
Operators (purchasers) as well as supervisory and operating staff must carry out program-
ming and data protection on Bizerba systems and devices exclusively in accordance with
the Bizerba operating and programming instructions.
Only use equipment for its intended purpose.
3.2 System-related sources of hazards
WARNING Incorrect supply voltage!
Destruction of electric components, fire hazard.
–
Do not connect device to the main supply if the mains data do not
correspond to the supply data of the device.
Mains data must be identical.
– Inform Bizerba Customer Service.
Check before connecting to mains!
Before connecting the device, check
–
mains data on identification plate.
– mains data of the mains supply.
CAUTION Switched-off device energized!
Even when the device is switched off, the device electronics is ener-
gized.
– Pull out the power plug to de-energize the device.
To Next Page
Loading...
