Bizerba CS 300 - Installation; Transport and storage

Operating instructions CS 300 Installation
6.110.98.5.01.40 en 4 - 1
4
4 Installation
Installation
CAUTION Incorrect use of weighing system!
Damage of weighing system.
–
Do not lift the weighing system at the load arms.
1
Load arms
2
Weighing system
Fig. 7: Weighing system
The weighing systems have been pre-set and verified ex-factory. The weighing systems
therefore do meet the requirements of the verification regulations.
In order to guarantee that the weighing system is still conform with these regulations after
installation into scanner and complete scanner scale into POS counter, the points descri-
bed in these installation and assembly instructions must be absolutely adhered to.
CAUTION No correct cable routing when inserting the weighing system into
a scanner!
Cables get into contact with mobile parts of the weighing system.
A shunt force is generated and the weighing results are not cor-
rect.
–
Route the cables in a way that no mobile parts get into contact with
the system.
Bizerba products undergo continuous further development and are subject to different
country-specific regulations.
Pictorial and graphic examples in the installation and assembly instructions may differ from
the supplied version.
4.1 Transport and storage
Always transport and store the device in its original packaging.