102 en | Keypad Installer menu Control Panels
2018.07 | 16 | F.01U.287.180 Installation Manual Bosch Security Systems, Inc.
Press Edit.
-or-
Press Enter to edit the phone destination and then Enter to edit the phone number for
the selected destination.
5. Delete existing characters, if necessary, and then enter the new phone number.
6. When finished, press Enter or Save to save the phone number. The keypad shows
Parameter saved.
7. Escape from the menu.
Phone Format
1. Enter the installer passcode, and then go the [1] Installer Menu.
2. Go to [1] Programming Menu > [1] Reporting > [1] Phone. The keypad shows the phone
number and phone format for the phone destination.
3. Use /Previous or /Next to go to the destination you want to edit.
4. Depending on keypad model:
Press Enter to edit the phone destination, and then press Next to go to the format
option, and then press Enter to edit the phone format for the selected destination.
5. Press Format and then Edit. Use /Previous or /Next to toggle between the Contact
ID and Modem4 option, and press Format while viewing the desired format to select it
and save the programming. The keypad shows Parameter saved.
6. Escape from the menu.
20.1.2 [1] Reporting > [2] Network menu parameters
Enhanced communications is the ability to communicate by some means other than a standard
digital dialer. The control panel can include four separate enhanced communication
destinations to which the control panel can route events. In this menu, you can enable
enhanced communication and edit the network address, network address, poll rate, and port
number for each destination (D1, D2, D3, and D4).
D1 Network address __________________________ Poll rate ___________ Port number _______
D2 Network address __________________________ Poll rate ___________ Port number _______
D3 Network address __________________________ Poll rate ___________ Port number _______
D4 Network address __________________________ Poll rate ___________ Port number _______
Enhanced Comm
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [1] Programming Menu > [1] Reporting > [2] Network > [1] Enhanced Comm. The
keypad shows the Enhanced Comm option as well as the current default value.
3. Depending on keypad model:
Press Enter and then press Disable or Enable.
-or-
Press Enter.
Press Save or Enter. The keypad shows Parameter saved.
4. Escape from the menu.
Network Address
Port Number
To Next Page
Loading...
Need help?
General
