Bosch B4512 Installation Manual

Control Panels Keypad Installer menu | en 107
Bosch Security Systems, Inc. Installation Manual 2018.07 | 16 | F.01U.287.180
4. Delete the existing number, if necessary, and then enter the new number. Use /
Previous or /Next to move to a different byte.
5. Press Save or Enter. The keypad shows Parameter saved.
6. Escape from the menu.
Default Gateway
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [1] Programming Menu > [2] Network > [1] Ethernet > (choose the bus module or
on-board) > [2] Address Parameters > [3] Default Gateway.
3. Press Edit or Enter to edit the gateway.
4. Delete the existing number, if necessary, and then enter the new number. Use /
Previous or /Next to move to a different byte.
5. Press Save or Enter. The keypad shows Parameter saved.
6. Escape from the menu.
HTTP Port Number
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [1] Programming Menu > [2] Network > [1] Ethernet > (choose the bus module or
on-board) > [2] Address Parameters > [4] Port Number.
3. Press Edit or Enter to edit the port number.
4. Delete the existing number, if necessary, and then enter the new number.
5. Press Save or Enter. The keypad shows Parameter saved.
6. Escape from the menu.
20.1.7 [2] Network > [1] Ethernet > (choose the bus module or on-board) > [3]
DNS Parameters menu
IPv4 Server Address
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [1] Programming Menu > [2] Network > [1] Ethernet > (choose the bus module or
on-board) > [3] DNS Parameters > [1] IPv4 Server Addr. The keypad shows the IPv4
Server Address current configuration.
3. Press Edit or Enter to edit the IPv4 Server Address.
4. Delete the existing number, if necessary, and then enter the new number. Use /
Previous or /Next to move to a different byte.
5. Press Save or Enter. The keypad shows Parameter saved.
6. Escape from the menu.
IPv6 Server Address
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [1] Programming Menu > [2] Network > [1] Ethernet > (choose the bus module or
on-board) > [3] DNS Parameters > [2] IPv6 Server Addr. The keypad shows the IPv6
Server Address current configuration.
3. Press Edit or Enter to edit the IPv6 Server Address.
4. Delete the existing number, if necessary, and then enter the new number. Use /
Previous or /Next to move to a different byte.
5. Press Save or Enter. The keypad shows Parameter saved.
6. Escape from the menu.

Bosch B4512 Specifications

General

Control Panel Type	Hybrid
Wired Zones	8
Outputs	2
Programmable Outputs	2
Onboard Ethernet	Yes
Cellular Communication	Optional
Series	B Series
Partitions	2
Type	Control Panel
Model	B4512
Manufacturer	Bosch
Input Voltage	16.5 VAC
Communication Formats	Contact ID, SIA
Power Supply	16.5 VAC
Backup Battery	12 V, 7 Ah
Operating Temperature	0°C to +50°C
Weight	1.5 kg
Compatibility	Bosch accessories