122 en | Keypad Installer menu Control Panels
2018.07 | 16 | F.01U.287.180 Installation Manual Bosch Security Systems, Inc.
6. When the keypad indicates that the repeater was replaced, escape from the menu.
20.2.6 [2] RF Repeater Menu > [3] Remove Repeater
In this menu, you can replace Repeater points.
Remove Repeater
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [2] Wireless > [2] RF Repeater Menu > [3] Remove Repeater. The keypad lists any
existing repeaters.
3. Use /Previous or /Next to scroll through the list of repeaters, and go to the repeater
you want to remove, or simply enter the repeater number.
4. Press Enter to remove the device. The keypad removes the device and shows Repeater
removed.
5. Escape from the menu.
20.2.7 [3] RF Diagnostic Menu > [1] RF Points
You can obtain certain wireless point diagnostic information using a keypad and this menu.
Point State
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [2] Wireless > [3] RF Diagnostic Menu > [1] RF Point Diagnostic > [1] Point State.
3. Use /Previous or /Next to scroll through the list, and go to the point for which you
want to view diagnostic information, or enter the point number.
4. Press Enter to view the state. The menu scrolls through the following sub-categories,
with the results of the diagnostic check: State, Tamper, Low-Battery, Maintenance.
5. When finished viewing the information, escape from the menu.
Point Signal
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [2] Wireless > [3] RF Diagnostic Menu > [1] RF Point Diagnostic > [2] Point
Signal.
3. Use /Previous or /Next to scroll through the list, and go to the point for which you
want to view diagnostic information, or enter the point number.
4. Press Enter to view the signal strength. The menu scrolls through the following sub-
categories, with the results of the diagnostic check: Signal Strengths, Level, Margin.
5. When finished viewing the information, escape from the menu.
20.2.8 [3] RF Diagnostic Menu > [2] RF Repeater Menu
You can obtain certain wireless point diagnostic information using a keypad and this menu.
Repeater State
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [2] Wireless > [3] RF Diagnostic Menu > [2] RF Repeater Menu > [1] Repeater
State.
3. Use /Previous or /Next to scroll through the list, and go to the repeater for which
you want to view diagnostic information, or enter the repeater number.
4. Press Enter to view the state. The menu scrolls through the following sub-categories,
with the results of the diagnostic check: State, Missing, Tamper, Low-Battery.
5. When finished viewing the information, escape from the menu.
To Next Page
Loading...
Need help?
General
