Bosch B4512 Installation Manual

Control Panels Keypad Installer menu | en 109
Bosch Security Systems, Inc. Installation Manual 2018.07 | 16 | F.01U.287.180
4. Delete existing characters, if necessary, and then enter the new characters.
5. Press Save or Enter. The keypad shows Parameter saved.
SIM PIN
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [1] Programming Menu > [2] Network > [2] Cellular > (choose the SDI2 cellular
module or plug-in module) > [4] SIM PIN. The keypad shows the current configuration.
3. Press Edit or Enter to edit the configuration.
4. Delete existing characters, if necessary, and then enter the new characters.
5. Press Save or Enter. The keypad shows Parameter saved.
20.1.9 [3] RPS > [1] RPS Passcode menu parameters
The control panel verifies the remote programming software at the central station has valid
access before connecting using the RPS passcode. In this menu, you can program the RPS
passcode.
RPS Passcode
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [1] Programming Menu > [3] RPS > [1] RPS Passcode.
3. Press Edit or Enter to edit the RPS passcode.
4. Delete the existing number, if necessary, and enter the new number.
5. Press Save or Enter. The keypad shows Parameter saved.
6. Escape from the menu.
20.1.10 [3] RPS > [2] RPS Phone Number menu parameters
The RPS Phone Number is the number the control panel dials to contact RPS or the Installer
Services Portal programming tool (available in Europe, Middle East, Africa, and China). In this
menu, you can program the RPS phone number.
RPS Phone Number
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [1] Programming Menu > [3] RPS > [2] RPS Phone Number.
3. Press Edit or Enter to edit the RPS phone number.
4. Delete the existing number, if necessary, and then enter the new number.
5. Press Save or Enter. The keypad shows Parameter saved.
6. Escape from the menu.
20.1.11 [3] RPS > [3] RPS IP Address menu parameters
The control panel can use a network hostname or an IPv4 address to call RPS or the Installer
Services Portal programming tool (available in Europe, Middle East, Africa, and China). In this
menu, you can program the IPv4 address or hostname for RPS or Installer Services Portal
programming tool communication.
RPS IP Address
1. Enter the installer passcode, and then open the [1] Installer Menu.
2. Go to [1] Programming Menu > [3] RPS > [3] RPS IP Address.
3. Depending on keypad model:
Press Edit as IPv4 for an IP address, or Edit as Name for a hostname.
-or-

Bosch B4512 Specifications

General

Control Panel Type	Hybrid
Wired Zones	8
Outputs	2
Programmable Outputs	2
Onboard Ethernet	Yes
Cellular Communication	Optional
Series	B Series
Partitions	2
Type	Control Panel
Model	B4512
Manufacturer	Bosch
Input Voltage	16.5 VAC
Communication Formats	Contact ID, SIA
Power Supply	16.5 VAC
Backup Battery	12 V, 7 Ah
Operating Temperature	0°C to +50°C
Weight	1.5 kg
Compatibility	Bosch accessories